AutoPage C3-RS915LCD - Manual (Page 11)

C3 RS915 REV. O1 11
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
C. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would
like to leave the motor running and the climate control on.
1. Before turning off the engine, press the button once on the transmitter and the LED indicator will flash 3
times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
D. TURBO CHARGE MODE:
Turbo charger mode keeps the engine running after arriving at your destination for a programmable period of
1, 3 or 5 minutes, This allows the vehicle’s engine time to conveniently cool down the turbo after you have left
the vehicle.
To activate:
1. While the engine is running, pull up the hand brake and place the transmission gear in the park position.
2. Before turning off the engine, press and release and buttons at the same time.
-- The LED will flash indicating the remote start has entered the turbo charger mode appear on LCD
remote.
3. Take the “Ignition Key” from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
NOTE: This feature only applies to vehicles with Turbo Charged Engines.
E. TIMER START:
This unit can be programmed to start and run the engine every 3 hours or punctually at the same time next
morning, the engine will run for the programmed running time and then shut down.
IMPORTANT : Timer Start should be used only in open areas, never start and run the vehicle in on
enclosed space as a garage or carport. Please be sure you fully understand this feature before use.
Enter timer start:
1. Ignition ON => OFF within 15 seconds Press button first, within 3 seconds press button.
2. 3 Hours Timer Start: The parking light will flash (3) times / icon appear. The siren or horn chirps (3)
times. The vehicle is now programmed to start every 3 hours.
Daily Timer Start : The feature is very useful for the driver who wants to run the vehicle punctually at the
same time next morning. Before set- up of the “Daily Timer Start”, you should set you time for engine
start.( see Timer Setting / Timer set- up for “Daily Timer Start, in Advanced users Mode) Please insure that
you fully understand this feature before programming the timer start mode.
Enter : Ignition ON => OFF, within 15 sec.
1. Press and hold “ F “ button until 3 beeps (you are enter table 3 feature option),
2. Press and release “ F “ button 4 times see flash on LCD display,
3. then press button to activate Daily Start.
Cancel timer start:
1. Turn the ignition on. The LED and parking light will flash (4) times. The horn chirps (4) times. or
2. Press the button twice to remote start the vehicle.
F. TEMPERATURE CHECK
With the built in temperature sensor you can monitor, Through the LCD screen, the present indoor
temperature of the passenger compartment of your vehicle.
Press and hold the transmitter “
F
”
button first until 3 chirps are heard. Then press the
F
Button three more
times so that TEMP appears on the remote. Within 3 seconds press button; the in-door temperature will