Bimba PCS - Manual (Page 34)

www.bimba.com Technical Assistance: 800-44-BIMBA 34
4. Gently insert the replacement probe into the cylinder, rotating it until it
slides through the hole in the piston. DO NOT FORCE THE PROBE INTO
THE CYLINDER. It should slide in freely with minimal friction. Hand
tighten until O-ring is seated, then rotate ONLY ¼ turn until with the ¼ inch
wrench. APPLYING TOO MUCH TORQUE WILL DAMAGE THE PROBE.
5. If there is a plug connector, slide it into the area in the rear cap.
6. Replace the rear cap and four cap screws using the torque in the table
below.
Bore Torque
(in-lbs.)
09 7
17 10
31 35
50 90
70 150