Refer ence man ual, Wir eless fuzzyscan, Using fuzzyscan in spp mode – Cino L780BT HC User Manual

Page 15

Advertising
background image

W

ir

eless FuzzyScan

R

efer

ence Man

ual

Getting Started

8

Using FuzzyScan in SPP Mode

Establish SPP Master Connection

Ensure the battery is fully charged. Please go to the folder of “Hardware” located in Bluetooth Advanced Setting of the

remote host device to check its device MAC address. Then prepare a 12-character Code 128 barcode of the remote host

device MAC address, or follow the step 4 to input MAC address by scanning 12 option codes.

Ensure a virtual COM port is available in your remote host for connecting the scanner. If not, please go to the folder of

Local Services” located in Bluetooth Advanced Setting. Click the “Add Serial Services” to add one more Bluetooth

COM port.

Power on the scanner within radio range and ensure the status indicator of scanner gives alternating red and green

blinks (in “Uninstall” state). If the scanner is not in uninstall state, please scan the “Uninstall” command first. Then scan

the “SPP Master Mode” command, and the status indicator of scanner will turn steady red.

Uninstall

SPP Master Mode

Scan a 12-character MAC address barcode, or scan 12 option codes and “FIN” command to confirm your inputs. The

scanner will give continuous short clicks and the link indicator of the scanner will flash blue quickly during the radio

connecting process. If the PIN Code or Passkey is requested for security connection, please enter “00000000” (default

setting).

The scanner will give 4 beeps in ascending tone to indicate the radio is connected. At the same time, the link indicator of

scanner will give 1 blue blink per 2.5 seconds to indicate the scanner is in radio-connected state.

Please note that if the scanner failed to connect to the host device within 30 seconds, the link indicator will give 3 blue

blinks per 2 seconds. But the scanner is still continuing to discover the host device for another 30 seconds before go to

sleep. In the interim, you still can scan “Uninstall” command to revert the scanner to uninstall state. If the scanner goes to

sleep already, you just need to press the trigger to wake up the scanner to continue the installation.

The installation procedures vary on different remote host devices, operating systems and the Bluetooth software driver.

Please consult your professional IT consultant to obtain necessary support if any problem has been encountered during the

installation processes.

Advertising
This manual is related to the following products: