Cino PL680BT HC - Manual (Page 11)

10
Batch Scanning (Inventory Mode)
Thanks to the specially designed Batch Scanning function, the scanner is
capable of storing up to 80,000 (PF/PL) or 100,000 (PA) EAN-13 barcode
data. It is an ideal cost-saving solution for inventory applications.
Press and hold the Function Key 2 for more than 3 seconds to enter Batch
Scanning, by which 3 beeps will be heard and the status indicator of the
scanner will blink green at regular interval during batch scanning
In this mode, all scanned barcode data will be stored into the memory storage.
You can scan and store the barcode data till the memory storage is full. If the
storage is full, you will hear 2 long beeps and the status indicator will blink
red twice to indicate out of storage. To exit the batch scanning, press and
hold Function Key 2 for more than 3 seconds.
You can also have your scanner entered or exited the batch scanning by
scanning the following commands.
Enter Batch Scanning
Exit Batch Scanning
Use Quantity Feature
The scanner supports quantity feature when it enters batch scanning. When
you use quantity feature, the quanity information and scanned barcode data
will be stored into the memory storage together. You can enter the quantity
information from 1 to 9999 by scanning the following quantity commands right
after you scan the barcode data.
Quantity 3
Quantity 0 Quantity 7
Quantity 4
Quantity 1 Quantity 8
Quantity 5
Quantity 2 Quantity 9
Quantity 6