Cino PL680BT HC - Manual (Page 3)

2
Preparations before Using
Install the Battery
Take off the battery cover from the scanner by
removing two blue tapes.
Ensure the battery contacts of the battery pack
are facing the charging contacts inside the
battery cavity. Then click the battery pack into
the battery cavity carefully.
Place the battery cover in the right orientation
onto the back of the scanner. Screw in and
tighten the four shipped M2 screws in
sequence by a small screw-driver in the
clockwise direction.
Charge the Battery via Power Supply Unit
Choose the right plug and slot it into the power
supply unit cavity until a “click” is heard. Then
plug the power supply unit into the wall outlet.
Please make sure the USB bus power switch
is in “OFF” position.
Plug the DC connector of the power supply
unit into the DC Jack of the cradle. The cradle
emits four beeps. For the Smart cradle, the
central indicator blinks blue once and side
indicators lights red. For the charging cradle,
the central indicator lights blue.
Place the scanner onto the cradle. When the
battery is fully charged, the status indicator of
scanner will light green.
Charge the Battery via USB 3.0 Port
The scanner can also be charged via the USB
3.0 port without the power supply unit. You
can connect the cradle to USB 3.0 port of host
device by a USB cable, then slide the USB
bus power switch to “ON”. After that, place the
scanner onto the cradle.
The scanner can also be charged via its micro
USB port by connecting the micro USB cable
to USB 3.0 port of host device or the
commercial USB power supply unit connected
to the wall socket.