ClassCo Jumbo Screen Caller ID ML300 - Manual (Page 6)

LONG DISTANCE CALL
If there is a long distance incoming
call, "LONG DISTANCE" apears
alternatively with the caller's name.
DIALING FROM
CALLER ID
1. When reviewing a Caller ID
record, press [DIAL] button to
dial the number shown on the
LCD display. If the number
format of the Caller ID is not
adjustable, the LCD display
shows “PICK UP HANDSET”.
Lift the Handset to dial the
number.
2. If you have pre-stored an area
code, the number format of the
Caller ID is adjustable (see the
"Important" section on page 12).
The LCD display shows “PICK
UP OR ADJ” after you press
[DIAL] button.
3. Press [DIAL] button again to
change number format among:
a) 7 digits (phone number)
b) 10 digits (area code +
phone number)
c) 11 digits (1 + area code +
phone number)
4. Lift the Handset to dial the
number shown.
IMPORTANT :
a)
You must pre-store an area
code before you can adjust the
number format. Refer to the
“Set Area Code” section on
page 8.
b) If you have set your local area
code, area code of all incoming
numbers will be compared
against your pre-set local area
code to determine if it is a local
call.
c) Only the last 7 digits of the
incoming number will be shown
on the LCD display if it is a local
call. If it is not a local call, 11
digits (1 + area code + phone
number) will be shown when
dialing back.
12:00AM 01/01 CALL #80 NEW
249-342-363
LONG DISTANCE
Operation
11
DELETING CALLER ID
RECORD
When the Caller ID record is full, it
automatically deletes the oldest
Caller ID record as a new call comes
in. You can also delete individual
call or all calls in the Caller ID record.
To Delete A Caller ID Record
1.
While reviewing a Caller ID
record, press [DELETE] button
and the LCD display shows
“DELETE CALL?”.
2. Press [DELETE] button again
to delete.
To Delete All Caller ID Records
1.
While reviewing a Caller ID
r e c o r d , p r e s s a n d h o l d
[DELETE] button for about 3
seconds. “DEL ALL CALLS?”
appears on the LCD display.
2. Press [DELETE] button again
to delete all records.
CALLER ID ON CALL
WAITING
If you have subscribed to the Caller
ID on Call Waiting service, ML-300ad
allows you to read the information
of the new caller from the LCD
display when you are on the phone.
IMPORTANT :
If there is more than one phone
connected to the line in your house,
ML-300ad will not receive Call
Waiting information when any of the
other phones are off-hook at the
same time.
1. When you are on the line and
hear a Call Waiting tone, the
new caller’s name and/or
number appear on the LCD
d i s p l a y. A n i c o n “ C . W. ”
indicates it is a waiting call.
2. Press [FLASH] button to switch
to talk with the new caller and
put the first caller on hold.
3. Press [FLASH] button again to
resume the phone conversation
with the first caller and to put
the new caller on hold.
12:00AM 01/01 CALL #80 NEW
C.W. 249-342-363
JOHN SMITH
Operation
12