Clay Paky A.LEDA B-EYE K20 - Manual (Page 19)

19 A.LEDA B-EYE
For greater programming ease using the DMX control unit and Media-
server Art-net, channel mapping is divided into BASIC ENGINE and
PIXEL ENGINE (see details in Channel Function).
BASIC ENGINE
Mode
This lets you select the projector operating mode for BASIC ENGINE,
selecting one of the two available modes:
• Standard (see channel mapping in Channel Function)
•
Shape (see channel mapping in Channel Function)
Source
It lets you assign the input source the projector receives signals from
dedicated to BASIC ENGINE. One of the two available sources can be
selected:
•
DMX
• Art-net
Universe
It lets you set “DMX Universe” for BASIC ENGINE mode to assign values
between 000 and 255 to a series of projectors (This option is valid only if
Source= Art-net)
DMX Address
It lets you select the address (DMX Address) for the control signal by
BASIC ENGINE. A DMX address between 001 and 512 can be selected.
NOTE: Without the DMX input signal, the displayed address (DMX
Address) blinks.
PIXELS ENGINE (Function Channel to 103-105 bit, see pag. 25)
Mode
This lets you select the projector operating mode for PIXELS ENGINE,
selecting one of the three available modes:
• Disabled
• RGB (see channel mapping in Channel Function)
• RGBW (see channel mapping in Channel Function)
Source
It lets you assign the input source the projector receives signals from dedicated
to PIXELS ENGINE. One of the two available sources can be selected:
• DMX
• Art-net
Universe
It lets you set “DMX Universe” for PIXELS ENGINE mode to assign values
between 000 and 255 to a series of projectors (This option is valid only if
Source= Art-net)
DMX Address
It lets you select the address (DMX Address) for the control signal by
PIXELS ENGINE. A DMX address between 001 and 512 can be selected.
REPEAT ON DMX
Enablement
It lets you enable/disable the transmission of the Ethernet protocol by
DMX signal to all the connected projectors.
• Disabled: DMX transmission disabled.
• Enabled on primary: DMX transmission enabled.
Universe
It lets you set the “DMX Universe” to assign values between 000 and 255
to a series of projectors. In this case
it refers to an Art-net input not read by the projector and re-transmitted to
other projectors.
SET UP MENU
NOTE: On grey the default options
Set Up
Basic
Engine
Mode
Source
Universe
Dmx
Address
Pixels
Engine
Mode
Source
Universe
Dmx
Address
Repeat
on DMX
Enablement
Universe
Continue ➔