Clay Paky A.LEDA B-EYE K20 - Manual (Page 20)

ETHERNET INTERFACE
It lets you set the Ethernet settings to be attributed to the projector.
Control Protocol
It lets you select the Art-net “Control Protocol” to be assigned according to
the control unit used. The following options are available:
• Disabled
• Art-net on IP 2.x.x.x
• Art-net on IP 10.x.x.x
• Custom IP
If the Control Protocol option is set on Disabled, when an IP address (IP2,
IP10 or IP Custom) is selected, the projector immediately initializes the IP
address that was just selected.
If the Control Protocol option is enabled (IP2, IP10 or IP Custom) and a
new one is selected that is different from the previous one, the projector
must be restarted so that it will be correctly initialized.
Custom IP address
Allows you to set the IP address by the user default.
Custom IP mask
Allows you to set the Subnet Mask by the user default
FIXTURE ID
It lets you set the “Fixture ID” to be assigned to the projector. An “ID”
between 000 and 255 can be assigned.
PAN / TILT
Invert pan
Used for reversing Pan movement.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
PAN inversion.
3) Press F to confirm the selection or LEFT D to keep current settings.
Invert tilt
Used for reversing tilt movement.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off) Tilt
inversion.
3) Press F to confirm the selection or LEFT D to keep current settings.
Swap Pan-Tilt
Used for swapping Pan and Tilt channels (as well as Pan fine and Tilt fine).
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
Pan and Tilt channel swap.
3) Press F to confirm the selection or LEFT D to keep current settings.
Encoder Pan-Tilt
Used for enabling the Pan / Tilt encoders.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
Pan / Tilt encoders.
3) Press F to confirm the selection or LEFT D to keep current settings.
You can quickly disable the Pan and Tilt Encoder by simultaneously
pressing the UP
B and DOWN C keys in the ''Main Menu''.
P/T Homing Mode
Lets you set the initial projector Reset mode.
1) Press
F , the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following settings:
OPTIONS MENU
Swap
Pan-Tilt
On
Off
Encoder
Pan-Tilt
On
Off
Pan / Tilt Option
Invert
Pan
On
Off
Invert
Tilt
On
Off
P/T Homing
Mode
Standard
Sequenced
20 A.LEDA B-EYE
Ethernet
Interface
Control
Protocol
Fixture ID
Set Up