Clay Paky ALPHA SPOT QWO 800 “ST” - Manual (Page 22)

22 ALPHA SPOT QWO 800 & “ ST ”
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
Ball. IN (Ballast IN Fan)
Eff.IN (Effects IN Fan)
Lamp (Lamp Fan)
PwrSp (Power Supply Fan)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the
projector, each channel is associated with one of the following three
parameters:
• n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
NETWORK PARAMS
Allows the "Network" parameters of the projector to be displayed or:
IP address: Internet Protocol address (two projectors must not have the
same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control: the projector’s Ethernet Address
LAMP
Used for turning lamp on and off from the projector control panel.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to turn the lamp on (On) or off (Off)
3) Press F to confirm the selection or LEFT D to keep current settings
and return to the top level.
RESET
Used for resetting the projector.
1) Press
F to reset the projectors, a confirmation message (Are you sure
?) appears on the display.
2) Select YES to starting reset the fixture or NO to keep the current setting
and return to the top menu level.
CHANNEL
Used for setting channel levels from the projector control panel.
1) Press
F - the first channel appears on the display.
2) Use the UP B and DOWN C keys to select the required channel:
3) Press F and use the UP B and DOWN C keys to select the
required DMX level (value between 0 and 255).
4) Press LEFT D to return to the top menu level.
MANUAL CONTROL
Lamp
Manual
Control
On
Off
No
Yes
Reset
Network
params
Dmx
Monitor
Sensor
Status
Fans
Monitor
Fan Speed (RPM)
Ball.In. XXXX
Eff.In XXXX
Lamp XXXX
PwrSP XXXX
Channel
TEST
Allows you to check the proper functioning of effects.
1) Press
F to return to the top menu level.
2) Use the UP B and DOWN C keys to select the required test.
3) Press F to confirm the selection or LEFT D to keep current settings.
Test sequence:
• Pan - Tilt effects (Pan & Tilt)
• Colour effects (CMY, colour wheel / CTO)
• Beam effects (Stopper-Strobe / Dimmer / Iris / Prism / Frost / Focus /
Zoom / Animation Disk)
• Gobo effects (Fixed gobo / Rotating gobo)
• All effects
TEST MENU
Test
Pan-Tilt
Colour
Beam
Gobo
All