Clay Paky SHOW BATTEN 100 AS - Manual (Page 18)

18 SHOW BATTEN 100
SET UP MENU
SET UP - DMX ADDRESS
Use to set the DMX address to be assigned to the projector according to the type of preset Channel Mode:
•
Standard Address: a DMX address between 1 and 503 can be selected.
•
Extended Address: a DMX address between 1 and 463 can be selected.
PLEASE NOTE: If there is no DMX input signal, the projector address flashes.
SET UP - CHANNEL MODE
Use to set the projector operating mode selecting one of the following:
•
Standard: maximum 10 DMX channels occupied.
•
Extended: maximum 50 DMX channels occupied.
SET UP - ARTNET INTERFACE - CONTROL PROTOCOL
Use to set the Artnet Control Protocol selecting one of the 4 options available:
•
Disabled: Control protocol disabled.
•
Net IP 2.x.x.x.: Import the Artnet network belonged to.
•
Net IP 10.x.x.x.: Set the alternative Artnet network belonged to.
•
DHCP: IP addresses assigned by DHCP server.
SET UP - ARTNET INTERFACE – REPEAT ON DMX
Use to turn the Repeat on DMX function ON or OFF. When ON, the DMX flow set via Artnet is repeated on
DMX cable.
SET UP - ARTNET INTERFACE – UNIVERSE
Use to set the DMX Universe to be assigned to the projector according to the type of set Channel Mode:
•
Standard Mode: a DMX universe between 0 and 255 can be selected.
•
Extended Mode: a DMX universe between 0 and 15 can be selected.
PLEASE NOTE: If there is no incoming Artnet signal, the projector universe flashes ( Euni=Extended Universe
/ Suni=Standard Universe).
SET UP - ARTNET INTERFACE – NETWORK SAFETY
Use to turn the Network Safety function ON or OFF.
When the Network Safety function is on, if projectors are connected via Ethernet cable in "daisy chain", the
CPU is battery powered and the Artnet signal is not interrupted but propagated when a projector is off.