Clay Paky SHOW BATTEN 100 AS - Manual (Page 20)

20 SHOW BATTEN 100
INFORMATION MENU
INFORMATION MENU – SYSTEM VERSION
Use to view the Appliance release (Application firmware) and Boot release (Security software) firmware
versions loaded in the CPU.
INFORMATION MENU – FIXTURE HOURS
Use to view total projector operating hours from manufacture to date (Total Hours) or operating hours since
the last user reset (Partial Hours).
To reset Partial Hours, press UP and DOWN together for 5 seconds till “Rst?” appears; then press “Enter” to
reset.
INFORMATION MENU – LED HOURS
Use to view total LED operating hours from manufacture to date (Total Hours) or operating hours since the
last user reset (Partial Hours).
To reset Partial Hours, press UP and DOWN together for 5 seconds till “Rst?” appears; then press “Enter” to
reset.
INFORMATION MENU – LED TEMPERATURE
Use to view real-time LED working temperature (Temperature) or maximum LED temperature from last user
reset (Max Temperature).
To reset Maximum Temperature, press UP and DOWN together for 5 seconds till “Rst?” appears; then press
“Enter” to reset.
INFORMATION MENU – DMX MONITOR
Use to view the DMX input level in bits for each projector channel (value between 0 and 255 bits).
INFORMATION MENU – TILT SENSOR
Use to view a projector Tilt position level (value between nn and nn).
INFORMATION MENU – NETWORK PARAMETERS
Allows the "Network" parameters of the projector to be displayed or:
•
IP Adress: Internet Protocol address (2 projectors must not have the same IP address)
•
IPmask: 255.0.0.0.
•
MAC address: Media Access Control (projector’s Ethernet Address).