Clay Paky SHOW BATTEN 100 AS - Manual (Page 21)

21 SHOW BATTEN 100
MANUAL CONTROL MENU
Use to set a projector control panel channel level to manually control each effect without the need of a DMX
input signal (values between 0 and 255 bits).
TEST MENU
Use to check correct effect operations, activating preset projector memory movements.
ADVANCED MENU
Enter access code 1234 to open the Advanced menu (only recommended for expert users).
ADVANCED MENU – FIRMWARE UPLOADER
Use to transfer software from one projector to all the others connected to it selecting between Appl. upload
and Boot upload.
ADVANCED MENU – TILT CAL
Use to recalibrate Tilt position with any problems.
ADVANCED MENU – RESET
Use to reset the projector CPU with any problems.
These errrors can be shown on the display, the description on this list, can help the user to identify the faulty.
ERROR LIST
Error Identifier Description
W04 BAT_ALERT Battery guard voltage Display warning
W12 LED_MAX_TEMP
Board maximum temperature reached LED current derating,
Display warning
E13 LED_OVER_TEMP
Board over temperature after derating Display warning, Stop
working, LED power off
E33 INIT_ERROR Startup procedure errors Display warning
W34 FW_UPLOADING
Firmware uploading in progress Display progress status, current
image still running
W35 FW_UPLOADED
Firmware uploading terminated with success Display new
version, new image runs after fixture restart
W36 FW_UPLOAD_ERR
Firmware uploading terminated without success Display
warning, current image still running
W37 FW_BAD_CRC
Firmware uploading terminated with CRC error Display warning,
current image still running
E38 FW_CORRUPTED Firmware image corrupted Display warning, run backup image
W49 SENS_CAL_FAIL Hall Sensor error