Dolby Laboratories HT2030 - Manual (Page 37)

OPERA
TION
37
Radio Operation
Presetting Radio Stations
You can preset up to 30 FM and AM stations. Before
tuning, make sure you have turned down the volume to
the minimum level.
11
Press RADIO.
FM or AM appears on the front panel display and radio
information appears on the TV screen.
22
Press RADIO repeatedly to toggle between AM
and FM.
33
Press and hold TUNING (v v /V V ) on the front panel
until the frequency indication starts to change,
then release.
Scanning stops when the DVD Receiver tunes in a
station. “STEREO” (for stereo program) appears on the
front panel display.
44
Press MEMORY.
A preset number will flash on the front panel display.
55
Press TUNING (v v /V V ) on the front panel to select
the desired preset number.
66
Press MEMORY again.
The station is stored.
77
Repeat steps 3-6 to store other stations.
To tune in a station with a weak signal
Press TUNING (v/V) repeatedly in step 3 to tune in the
station manually.
To clear all memorized stations
Press and hold MEMORY until “MEM CLEAR” appears
on the front panel display. Then press MEMORY again
to clear all stations.
ote
If all 30 stations have already been entered, MEM FULL
will appear on the front panel display for a moment and
then a preset number will flash. To change the preset
number, follow steps 5-6 as above.
Listening to the Radio
Before you begin, be sure to preset your favorite radio
stations in the DVD+VCR’s memory (see “Presetting
radio stations” at left).
11
Press RADIO.
FM or AM appears on the front panel display and radio
information appears on the TV screen. The last received
station is tuned in.
22
Press PRESET (v v /V V ) repeatedly to select the
desired preset station.
33
Adjust the volume by rotating the VOLUME
knob on the front panel or by pressing VOLUME
+/- on the remote control repeatedly.
To turn off the radio:
Press POWER to turn the DVD+VCR off or select
another function mode (DVD, VCR, or AUX).
To listen to non-preset radio stations:
For manual tuning, press TUNING (v/V) on the front
panel repeatedly.
For automatic tuning, press and hold TUNING (v/V)
for about two seconds on the front panel.
For your reference
If an FM program is noisy
Press AUDIO so that “STEREO” disappears from the
front panel display. There will be no stereo effect, but
the reception will improve. Press the AUDIO button
again to restore the stereo effect.
To improve reception
Realign the antenna.