Connecting to vms, Dependencies, Connect to vm – ClearCube ClientCube 2 with KM User Manual
Page 13
Page 13 of 14
P/N G0200161 Rev F, 1.5.01.19.2015
ClearCube Technology, Inc. 3700 W Parmer Lane Austin, TX 78727 (512) 652-3500 www.clearcube.com
Connecting to VMs
Dependencies
If you are connecting to VMs, these instructions assume you are using VMware products and have
your environment functioning and configured (including Domain users associated with VMs).
For more information about zero client configuration, see the appropriate zero client Quick Start
Guide (included) and PC-over-IP System User’s Guide (download from ClearCube Support).
Connect to VM
The table below shows how to connect to a VM from a zero client. These instructions assume you
have completed the steps shown in “
Configuring Zero Clients for VM Connections
on page 11
Step
Action
1
From a zero client OSD, press CTRL, CTRL, F11, b to ensure the mouse is in
relative mode. Click Connect. When the Certificate Warning is displayed, click
Continue.
2
Enter the user credentials and click Login.
3
Select a VM to connect to, and click Connect. The VM desktop is displayed.
The mouse is unable to perform Seamless Cursor Switching to switch from one
monitor (or computer) to the next. Press CTRL, CTRL, F11, c to switch the mouse
to absolute mode.
4
Move the mouse to the next monitor to switch to the next zero client in the ClientCube 2.
Once you are on the next zero client’s OSD, press CTRL, CTRL, F11, b to toggle to
relative mode so you can navigate the screen. Click Connect to connect to another VM
as shown in the previous steps.
5
Once connected to the desktop, press CTRL, CTRL, F11, c to toggle the mouse mode.
Seamless Cursor Switching (SCS) is now enabled and you can switch from zero client to
zero client by moving the mouse (see the included Secure KM Switch User Manual for
information about SCS). Repeat this process and connect to the remaining zero clients in
the ClientCube 2 and toggle the mouse mode by pressing CTRL, CTRL, F11, c to
enable Seamless Cursor Switching for all zero clients in the ClientCube 2.