Compass Atom 500 - Manual (Page 13)

M2.5x6 Self
Tapping Bolt
Canopy
Canopy Insert
Use AB Glue
A B
M2.5x6 Self Tapping
Bolt X 2
Drill a 6.5mm D
Hole here
A B
A B A B
00 10 20 30 40 00 10
Canopy
00 10 20 30 40 00 11
Rotor Direction
5. Check that main blades, paddles and tail blades are installed in the right direction.
6. Check that there are no missing or damaged parts, never fly with any damaged parts.
7. Make sure all electronic devices are firmly fastened and connected.
8. Before starting the motor, make sure the IDLE switch is OFF and throttle stick is in the low position.
9. Only turn off the transmitter after turning off the receiver.
1. Ensure that receiver & transmitter battery are fully charged.
2
Check all bolts and screws are tight
. .
3 Repeat step 9 to check all servo functions are correct.
.
4 Ensure tail and gyro direction are correctly set
. .
00 10 20 30 40 00 12
Pre Flight Check
Place the Canopy onto the Frames and mark
the right position of the Canopy Inserts. Apply
AB Glue to fix the Canopy Insert onto the
canopy.
When the Rotor spins clockwise the Tail Blades should turn
clockwise as well watching the Tail Rotor from the Tail Fin side.
If not Belt is installed the wrong way and has to be corrected.