Compass Atom 500 - Manual (Page 6)

0 10 20 30 40
3
Boom & Tail Rotor
M3x40 Cap Head Bolt x4
Crimping Belt damages the Tensile Cords
and will result in premature failure.
M3 Washer x2
M3 Nylon Lock Nut x6
M2.5x6 Cap Head Bolt x2
Use Threadlock
M3x40 Cap
Head Bolt
M3 Nylon Nut
Slide the Tail Boom through the
Tail Boom Mount. Twist the Tail
Belt 90° to the right before
inserting it to the Idler Pulleys.
M2.5x8 Self Tapping Bolt
M2.5 x8 Self Tapping
Bolt X 2
Bearing Retainer
M3x25 Cap
Head Bolt
M3 Nylon
Nut
Vertical Fin Mount
M3 Washer
M2.5x6 Cap
Head Bolt
Insert the Tail Boom
fully into the Tail Gear
Case before tightening
the 2.5x6mm Bolts.
Be careful not to over tighten the
Bolts when attaching the Tail Rotor
Blades. The Tail Blades should be
able to move with a slight amount
of resistance within the Tail Blade
Holders.
Tail Set
These Bolts are only used to
compress the boom, please do
not screw them the whole way in.
See Page Team Tips!