Delta RMC151 - Manual (Page 14)

RMC150 Startup Guide
Step 7: Test an Actuator
You will now test an actuator such as a hydraulic valve or a motor. You
will use the Direct Output command to send a voltage to the actuator.
The actuator must already have been wired to the RMC.
1. Check the machine and make sure that the axis may safely move
in both directions.
2. In the Project tree, double-click
Axis Tools.
3. In the Axis Status Registers, on
the Basic tab, look at the
Control Output.
It should be 0.
5. In the Command Tool, in the axis the actuator is connected to,
click the button.
12 Delta Computer Systems, Inc.