Ditch Witch OnGrade - Manual (Page 47)

Systems and Equipment - 46
OnGrade Operator’s Manual
Inspection Tools
CMW
Camera/Video Recorder
Operation
Connection
1. Spool off enough cable to pass competely through installed pipe.
2. Remove nut on back of camera and connect
camera cable to video camera on the trolley
(1). Tighten connection firmly.
3. Seat cable gland into bracket at the back of
the trolley (2). Tighten thumb nut to prevent
cable from pulling on the back of the camera
as the trolley is pulled through the pipe.
4. Connect 12V power supply to the power
connection on cable spool.
5. Connect the digital video recorder to the
connection on the cable spool.
6. Verify the recorder is receiving video feed
from the camera.
7. Verify SD card is installed in the recorder if
digital recording of video feed from the camera is needed.
8. Press “record” on the video recorder to begin video capture.
IMPORTANT: See camera and video recorder operator’s manuals for operating instructions.
IMPORTANT: Camera cable spool provided has 500’ (152 m) of cable. If installed pipe run is
longer than this, run trolley as far as possible and then set up trolley in other end of installed pipe
to record the rest of the run.
e14om019t.eps
1 2