East Coast Supercharging ECS Alky C7 - Manual (Page 16)

Step 1
Strip insulation from end of pump cable and separate wires. Note there are three wires.
Red, Black, bare wire. Strip insulation Red and black wires. About ¼ inch is fine. And
use the small supplied Male spade terminals. Crimp the terminals from the bottom as
shown.
Step 2
Slide large black heat-shrink over terminals and cable. Next is slide white heat-shrink
over Bare wire, slide Red heat-shrink over Red wire. Slide Black heat-shrink over Black
wire. Then push male spades into their respective colored female connectors as shown.
Next is slide heat-shrink over terminals.