East Coast Supercharging ECS Alky C7 - Manual (Page 6)

Now the pump we need to attach the supplied steel bracket and get rid of the mounting
plate it has. Once the bracket is mounted to pump, install the 90 degree pump fittings
in by hand. Note the inlet fitting will face towards the frame and the outlet fitting will
point straight up. I feed the 28 inch hose from the top of the drivers fender by the
brake boosterand now thread it onto the outlet fitting. Tighten it as access will be hard
once pump is set in place. Now pull wire loom off and use the supplied ¼ bolt to bolt
the pump to the wire loom hole. Next is install the feed hose and tighten its fittings.
Remember these fittings are soft brass. Don’t force them more than needed.