Echelon NodeBuilder Resource Editor - Manual (Page 50)

property of the same type that applies to the same interface within a functional
profile. For example, you can create multiple SCPTmaxSendTime configuration
properties that apply to different network variables, but you cannot create two
SCPTmaxSendTime configuration properties that apply to the same network
variable. You can, however, create an array of SCPTmaxSendTime configuration
properties that apply to a single network variable.
2. Select the new configuration property to set options for it. The Properties (rightmost)
pane appears as follows:
3. Enter the following information:
Name The name of the configuration property member
within the functional profile. This name may
contain only letters, numerals, and the underscore
character, and it must not start with a digit. A
prefix is not required, but “nci” and “cp” are
commonly used. If you do not use this prefix,
start the configuration property name with an
initial capital and use mixed case for the name.
42 Creating and Modifying Resources