Electrocompaniet ECI 6DS - Manual (Page 10)

10
ENG
1. When pairing is successful press ENTER to select the name of the newly
paired device (ECI 6DS). ( image 1 )
2. Next step, you can select to change the key mapping for the the volume
control keys (V+/V-/Mute). This will allow you to remap the volume control
keys to a IR device known to ECT 4. Pressing the volume keys will then send
volume changes using IR to the selected IR device. Choose "Don't change" to
let the volume keys control the volume on ECI 6DS using RF.
3. Last step is to choose a hotkey for the device (with the possibility to change
zone). Choose from A,B,C,D to assign the device to a Hotkey. ( image 3 )
When this is done, ECT 4 automatically tries to establish a session with the
new device. Name, keymapping and hotkey association can also be changed
later in the "User Settings" menu.
Operating the ECI 6DS with ECT 4.
After ECT 4 has been paired with ECI 6DS, you can start operating all
functions. The ECT 4 is working in radio communication mode and you
don't need to point the remote control at the ECI 6DS.
If the remote control is moved out of radio communication range, the mes-
sage "There was no response from the selected device" will be displayed.
Return to within the radio communication range and select the ECI 6DS
from the device selection menu, or by pressing the hot key selected.
image 1 image 2 image 3
A B C D
ECT 4 Remote Control