Electrocompaniet EMC1-UP User Manual
Page 4
5
Mains
Before connecting to Mains check that the mains voltage printed on the rear
panel of the CD Player corresponds to the line voltage in the territory were you
intend to use the unit.
How to avoid damages
A good operating practice is to turn off all equipment before any connections
or disconnections are made. Do not under any circumstances connect or
disconnect equipment when power is turned on. The design of the RCA plug
generates a huge transient when inserted. Connecting or disconnecting
equipment with the power on could severely damage both speakers and
amplifier(s).
How to avoid noise problems
The EMC 1UP contains delicate circuits that are sensitive to magnetic strayfields.
The unit should not be place near mains transformers, TVs etc. Care should
also be taken regarding placement of the interconnect cables. Do not run
interconnect cables in parallel with mains cords and loudspeaker cables.
Keep interconnect cables as short as possible.
Replacing remote control batteries
Replace used batteries by gently inserting your fingernail or small screwdriver in
the groove on the left side of the battery compartment cover. Lift the cover off, and
insert a fresh set of batteries. Be careful to follow the + and - polarity indications
at the bottom of the battery compartment. Battery: 2 x LR03 / AAA: 1.5Volts.