Electrocompaniet EMC1-UP - Manual (Page 9)

10
Connecting the audio components
Multi
Front Panel Controls
The power on/off button is localised in the center of the front panel.
Generally, we recommend that you use the Standby button located on the
remote control.
The display will go dark. The e- sign on top of the unit will still be lit, indicating Standby
mode.
When not using the EMC 1UP for a long period, turn the main switch off and
disconnect the unit from the mains outlet.
The four buttons on the right front panel have the following functions:
Top button
= start/play
Right button = next
Left button
= previous
Lower button = stop
How to power up your system
You should always power up your system the following way: Signal sources (CD
player, tuner etc.) first. Allow a 30 seconds warm-up before you turn on the
amplifier(s). When switching off your system: Start with the amplifier(s), then the
signal sources.
Loading a Disc
1. Load the disc by gently pushing the drawer marked: ELECTROCOMPANIET
towards the rear of the unit. «Open» is shown on the display.
2. Place the disc on the spindle. Then place the CD-clamp on the spindle. The
clamp now securely fastens the disc.
3. Pull the cover all the way home. The CD player must first read and load vital
information from the disc. This process, indicated by a flashing display, takes
approximately three seconds. Tracks and total time are displayed.
4. Press start/play and the first track starts to play.
5. When changing a disc, press the stop button on the front panel or on the
remote control before opening the drawer.
6. If the drawer is opened during playback, it will take the disc a few seconds to
spin down.
7. Do not touch the disc until it has come to a complete standstill.
Warning:
The laser pick-up is located behind the spindle.
NEVER look directly into the laserbeam!!!
Under normal circumstances the laser needs no cleaning.
Do not use any kind of “cleaning CDs”!