Elenco Surface Mount Generator Kit - Manual (Page 10)

-9-
FINAL ASSEMBLY
Figure K
r Fit the PC board assembly into the top
case, making sure that all switches and
pots come through the holes in the panel
as shown in Figure K.
r Place the washers onto their locations as
shown in Figure K, being careful to check
the sizes. Then, tighten the hex nuts onto
the potentiometers and rotary switch,
noting their size as shown in Figure K.
r Peel off the protective backing on one side
of the double-sided tape and adhere it to
the bottom case in the location shown in
Figure L.
r Peel off the remaining protective backing
from the tape and adhere the battery
holder to the tape, with the battery holder in
the direction shown in Figure L.
r Obtain a 9 volt battery (alkaline preferred).
Press the battery snap onto the battery
terminals (see Figure L) and then mount
the 9V battery onto the holder.
9mm Hex
switch nut
9mm x
15mm Flat
washer
8mm x 14mm
Washers
7mm Hex
pot nuts
Top case
Figure L
Top case
Bottom case
9V Battery
Battery snap
Battery holder
Double-sided tape