Elenco Surface Mount Generator Kit - Manual (Page 11)

-10-
r Remove the backing from each rubber foot and
place them in the locations shown in Figure M.
r Assemble the top and bottom case sections and
fasten with four 2.8 x 8mm self-tapping screws as
shown in Figure M. Make sure the slots on the
side line up with one another.
r Turn the shafts on the two potentiometers and
rotary switch fully counter-clockwise. Push the
three knobs onto the shafts so that the line on the
knobs are on the points shown in Figure N.
Figure M
2.8 x 8mm Screws
2.8 x 8mm
Screws
Rubber feet
Rubber
feet
Slot
Figure N
FINAL ASSEMBLY (continued)