Elenco Surface Mount Generator Kit - Manual (Page 7)

ASSEMBLE COMPONENTS TO THE PC BOARD
Care must be given to identifying the proper components and in good soldering habits. Refer to the soldering
tips section in this manual before you begin installing the components. Place a check mark in the box after
each step is complete.
R1 - 620Ω 5% 1/8W Res. Chip
(621)
C7 - 10µF Electrolytic Chip
(see Figure A)
U1 - XR-2206P IC Surface Mnt.
(see Figure B)
R9 - 100kΩ 5% 1/8W Res. Chip
(104)
R8 - 10kΩ 5% 1/8W Res. Chip
(103)
R5 - 3.9kΩ 5% 1/8W Res. Chip
(392)
R6 - 200Ω 5% 1/8W Res. Chip
(201)
R4 - 22kΩ 5% 1/8W Res. Chip
(223)
C5 - .01µF Capacitor Chip
(in the bag with lytic capacitors.)
C4 - .1µF Capacitor Chip
(in the bag with IC.)
C3 - 1µF Electrolytic Chip
(see Figure A)
C6 - 820pF Capacitor Chip
(in the bag with resistors.)
C2 - 10µF Electrolytic Chip
(see Figure A)
C8 - 10µF Electrolytic Chip
(see Figure A)
R7 - 8.2kΩ 5% 1/8W Res. Chip
(822)
Figure B
Mount IC with pin 1 as shown on the PC board
illustration.
Figure A
This capacitor is
polarized, be sure
that the (+) and (–)
sides are positioned
correctly.
Warning: If the capacitor is connected with
incorrect polarity, it may heat up and either leak
or cause the capacitor to explode.
-6-