EMM Labs Switchman MK II - Manual (Page 12)

Page 12 of 13
3.5 Sticky Templates
This feature offers a modified Template Load mode. Sticky Templates are enabled
through DIP switch (OPTIONS) on the Main Unit’s back panel - the actuator on
position
4
should be ON.
Important: SwitchMan Main Unit reads OPTIONS switch only at start-up time. Set
the desired configuration before powering up your system.
The initial procedure is similar to the “normal” Template Load mode: press TEMP
button and then one of template selector buttons. However, when the template is
loaded in, your system does NOT return to Volume Control mode. The TEMP LED
and the template selector LED stay on.
At this point, another template can be loaded immediately, just press another
template selector button. New template settings are effective immediately. The
master volume display and input system indicator LEDs are updated.
The main rotary knob is active, and the master volume is adjustable.
The MUTE function is active.
The only way to cancel this mode is to press the TEMP button again. The system will
return to Volume Control mode.
3.6 Soft Mute
This feature offers Mute with reduced attenuation. Pressing MUTE button will drop
the Master Volume by 26 dB on all channels.
Normally, the Mute applies full attenuation to all channels. Enabling Soft Mute
feature allows the program to be still audible.
Soft Mute is enabled through DIP switch (OPTIONS) on the Main Unit’s back panel -
the actuator on position
3
should be ON.
Important: SwitchMan Main Unit reads OPTIONS switch only at start-up time. Set
the desired configuration before powering up your system.