EMM Labs Switchman MK II - Manual (Page 13)

Page 13 of 13
4. Hints and Tips
• Selecting another input (
A
to
D),
or reselecting the current input again,
immediately puts the system into Volume Control Mode, thus escaping any other
mode the system is currently in.
The only exception to this rule is the Sticky Template mode where the only active
buttons are:
- TEMP (toggles back to Volume Control Mode)
- template selection buttons
- MUTE button.
• When inspecting settings of a given channel, you may choose to adjust that
channel right away. Press the TRIM button at this point - the channel selection
stays the same, but now the system is in Channel Trim Mode.
• The RESET button on the back of the Remote Unit restarts the Remote only;
however, the system returns to Volume Control mode at this point.
• The Remote Unit can be unplugged and plugged-in at any time. You may use this
as a sure-fire variant of System Lock feature.
Set up and adjust your system, then disconnect and hide away the Remote.
When the Remote is re-connected again, the display and LED indicators shall
update immediately. Pressing the RESET button on the back of the Remote
ensures that both units are synchronized.
• If you save the current settings (in a template of your choice,) your system set-
up survives power-down/power-up events.
• While in Volume Control Mode, press SHIFT-TRIM button on the Remote to verify
the profile selection. The numerical display will show a
P0
or
P1
symbol. After
approx. 1 second, the display returns to normal operation.