EMM Labs PRE2-SE - Manual (Page 11)

011 Operational Features PRE2 STEREO PREAMPLIFIER OWNER’S MANUAL
Main Screen
1. Mute Button
Pressing the mute button initiates a 2-stage, sequential Mute
function. Soft Mute (-20dB from the current level), Full Mute,
and finally Mute Off. Mute is Off/disabled as soon as the
Volume knob is rotated or the Volume buttons are depressed
on the remote. Once Mute is off the PRE2 will return the
signal path to its current volume setting. A short fade-in is
performed to avoid audible transient artifacts.
2. Loop Button
The Loop function allows for the insertion of an external
device (e.g. signal processor) into the main signal path. There is no gain applied to loop return signal. The state of Loop path
is input-dependent. Each preamp input can engage the Loop as required.
3. PGM Button
The PGM (program) opens a pop-up menu with 4 main programming or configuration selections. New navigation buttons
will appear: Up, Down, Enter, and Exit. See “Programming Menu” section.
4. SAVE Button
The SAVE function immediately saves the state of the system in non-volatile memory. The following parameters are saved:
• Volume Step Number and Loop state - as set for each input
• Volume Display Units (steps or decibels)
• Volume Font: 7-Segment or a ‘Designer’ font
• LCD display Contrast and Brightness settings
• The default input to be selected upon power-up.
© 2014 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.