B remote control commands, Ieee 488.2 commands-quick reference, Ieee 488.2 commands—quick reference – EXFO PM-1100 Optical Power Meter User Manual
Page 77
Optical Power Meter
67
B Remote Control Commands
This section presents detailed information about the commands and
queries supplied with your PM-1100 Optical Power Meter.
IEEE 488.2 Commands—Quick Reference
The Optical Power Meter recognizes the main commands identified in
IEEE-488.2. The table below summarizes these commands. The
commands are fully explained on the following pages.
Command
Function
*CLS
Clear status command
*ESE
Standard event status enable command
*ESE?
Standard event status enable query
*ESR?
Standard event status register query
*IDN?
Identification query
*LOK
a
a.
This command can only be used with RS-232 communication.
Set Remote Lockout programming state
*OPC
Operation complete command
*OPC?
Operation complete query
*REM
Set Remote programming state
*RST
Reset command
*SRE
Service request enable command
*SRE?
Service request enable query
*STB?
Read status byte query
*TRG
(Not supported)
*TST?
Self-test query
*WAI
(Not supported)