EXFO RTU 310-310G IP Services Test Head - Manual (Page 116)

Creating and Starting a Test Case
104 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet Frame Analyzer Test Case
2. Port configuration:
2a. Select the port Connector
Type (Optical or
Electrical RJ-45). Optical is automatically selected for the
Ethernet 10G interface.
2b. For RTU-310select the port
number by clicking on
Port 1 or Port 2.
Port 1 (RTU-310 only) is
automatically selected
when IPTV is selected.
For RTU-310Dual Ports,
select the first port and
proceed with the rest of
the configuration for the
first port. However, before
clicking Finish, click Back
several times to return to the port setup window, select the
second port and proceed with the rest of the configuration for the
second port.
2c. For Electrical RJ-45, if required, select
the Ethernet port crossover check box
to inverse the pin-to-pair assignment of
the UTP cable used.
Note: At this point you should have a link up indicated in the Tree view tab. A
green LED indicates a link up while a red LED indicates a link down. For
electrical port, if the link is down, make sure that the Ethernet port
crossover setting is correct.
2d. Click Next.