Clock synchronization – EXFO RTU 310-310G IP Services Test Head User Manual
Page 412
System Tabs
400
RTU-310/310G
Clock Synchronization
Clock Synchronization
Note: Clock Synchronization is only available for Ethernet 10G.
Click System and Clock Synchronization.
RX
Configuration: Allows the selection and configuration of the input
clock. This clock will be used for test synchronization if External clock
has been selected during test setup and/or for the backplane
configuration when External clock mode is selected Interface Type:
Allows the selection of the clock interface. Choices are None, DS1, and
E1. The default setting is None.
Termination Mode: The termination mode is set to Term for DS1
and E1.
Line Coding: Allows the selection of the interface line coding. Choices
are:
For DS1: AMI and B8ZS. The default setting is B8ZS.
For E1: AMI and HDB3. The default setting is HDB3.
Framing: Allows the selection of the interface framing. Choices are:
For DS1: SF, and ESF. The default setting is SF.