EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual
Page 108
Advertising
Creating and Starting a Test Case
94
IQS-8100 Series Transport Blazer
Typical Test Cases
3. OTU Interface selection and configuration.
3a. Press OTU1 or OTU2. Choices depend on the
rates available on the Transport Blazer module.
3b. For OTU2 interface with Unframed mode, press
Next and go to step 6.
3c. Select the Enable FEC and Enable Scrambler check boxes if
needed. Refer to FEC TX on page 154 and OTU TX on page 157 for
more information.
3d. Press Next.
4. Select ODU TCM (TCM1 to TCM6) layers as required.
4a. Press Next or Finish.
5. Select the test Path/Mapping:
5a. From the data path
selector, select the
desired path/
mapping. Choices
depend on the
selected interface.
See Supported
Paths/Mappings on
page 59 for more
information.
Advertising