EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 82)

Creating and Starting a Test Case
68 IQS-8100 Series Transport Blazer
Typical Test Cases
3. Interface selection and configuration:
3a. Press the desired
interface: DS3,
DS1, E4, E3, E2, or E1.
3b. Select the Framing, Line
Coding, TX LBO (DSn interface
only), and RX Termination
Mode. Term, Mon, and Bridge
(DS1/E1 only) termination mode
are available. For more
information, refer to TX - DSn
Tabs on page 269 or PDH Tabs on
page 369 for the framing, Port TX
(Electrical Interfaces) on
page 138 for Line Coding and
LBO, to RX - DSn Tabs on page 269 or PDH Tabs on page 369 for
Termination Mode.
3c. For DS1, select the Enable FDL check box to allow facility data
link testing.
3d. For DS1/E1, select the Enable DS0/E0 check box to allow DS0 or
E0 testing.
3e. For DS3 interface, select the Enable FEAC check box to allow far
end alarm and control testing.
3f. Press Next or Finish.