EZ-ACCESS PASSPORT - Manual (Page 7)

Page 7 of
26
PROGRAMING YOUR WIRELESS REMOTE TRANSMITTER(S) AND RECEIVER
Your wireless remote comes pre-programmed for your VPL. Replacement and additional wireless remotes may
need programming. Below, and included with each new/replacement wireless remote, is the procedure for
wireless remote programming.
PROGRAMMING INSTRUCTIONS:
Each keyfob transmits its own unique internal address whenever a button on the keyfob is pressed. The
receiver needs to be programmed to respond to the keyfob transmitter it operates with. The following steps
configure the receiver to operate with a keyfob transmitter.
Up to twelve keyfob transmitters can be programmed to one receiver. Please read the entire programming
procedure before starting. Prior to programming the receiver, verify the receiver is connected to the input
power and the long-range antenna is installed into the connector on the receiver. When the receiver enters
program mode, all previously programmed transmitter addresses will be erased.
1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red
LED next to the program button illuminates (approximately 5 seconds). The receiver is now in the
transmitter program mode. Release the blue button. At this point all previously programmed transmitter
addresses are erased from the receiver's memory.
2. Press either button on the keyfob transmitter and verify the red LED on the receiver extinguishes and
then illuminates (blinks once). Release the button.
3. Repeat previous step for additional key fob transmitters that will operate with this particular receiver.
The red LED on the receiver will extinguish and illuminate one time for the first transmitter being
programmed, twice for the second, three times for the third, four times for the fourth etc. The receiver
will not respond to transmitters that have already been programmed.
4. If no transmitter switch is pressed for 5 seconds, the receiver will return to normal operation. The red
LED on the receiver will blink rapidly then extinguish. The receiver is now ready for use.
The receiver remembers its programming even if power is disconnected.