E-Z-GO FREEDOM TXT 2+2 - Manual (Page 27)

19
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
PORTABLE CHARGER INSTALLATION
Risk of electric shock. Connect charger power cord to an outlet that has been properly
installed and grounded in accordance with all local codes and ordinances. A grounded
outlet is required to reduce risk of electric shock – do not use ground adapters or modify
plug. Do not touch uninsulated portion of output connector or uninsulated battery
terminal.
Disconnect the DC supply before making or breaking the connections to the battery while
charging. Do not open or disassemble charger. Do not operate charger if the AC supply
cord is damaged or if the charger has received a sharp blow, been dropped, or otherwise
damaged in any way – refer all repair work to qualified personnel. Not for use by children.
To reduce the possibility of overheating that may cause serious damage to the charger and cre-
ate the potential for fire, do not block or obstruct the airways. Portable chargers must be
mounted on a platform above the ground or in such a manner as to permit the maximum air flow
underneath and around the charger.
Use charger ONLY on 48 volt battery systems. Other usage may cause personal injury and dam-
age. Lead acid batteries may generate explosive hydrogen gas during normal operation. Keep
sparks, flames, and smoking materials away from batteries. Provide adequate ventilation during
charging. Never charge a frozen battery. Study all battery manufacturers’ specific precautions
such as recommended rates of charge and removing or not removing cell caps while charging.
Portable chargers must be mounted on a platform above the ground or in such a manner as to per-
mit the maximum air flow underneath and around the charger.
Portable chargers are shipped with the vehicles. Prior to vehicle or charger operation, the charger must be removed
and mounted on a platform or wall above the ground to permit maximum air flow around and underneath the charger. A
dedicated circuit is required for the charger. Refer to the charger manual for appropriate circuit protection. For opti-
mum performance and shortest charge times, place the charger in an area with adequate ventilation. The charger
should also be placed in an area that will be relatively free of dirt, mud, or dust since accumulations within the fins of the
charger will reduce their heat-dissipating qualities. Optimal cooling also occurs when the charger is placed on a hori-
zontal surface with the fins vertical. More airflow from below the charger will help cool the fins, so placement above
open areas or areas with cut-outs for airflow is desirable. If the charger is operated in an outdoor location, rain and sun
protection must be provided. The charger may get hot during operation and must be placed such that risk of contact by
people is reduced. The charger may be mounted on a wall or shelf using #10-M5 screws. The charger’s status display
must be visible to the user.
Looping the DC cord through the steering wheel when charging serves as a good reminder to store the cord out of
the way when finished with charging. The DC plug can be damaged by driving over or catching the cord on the vehi-
cle when driving away.
To reduce the possibility of a physical hazard that could result in an electrical shock or electrocu-
tion, be sure that the charger plug is not damaged and is inserted into a grounded receptacle.
The power (AC) cord is equipped with a grounded plug; do not attempt to pull out, cut or bend
the ground post.
NOTICE