E-Z-GO TERRAIN 1000 - Manual (Page 50)

B
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
41
Owner’s Guide
HARDWARE
Generally, three classes of standard hardware and three classes of metric hardware are used in the vehicle. Grade 5
hardware can be identified by the three marks on the hexagonal head; grade 8 hardware is identified by six marks on the
head; grade 2 hardware is unmarked. The class specification is marked on metric hardware.
Periodically, the vehicle should be inspected for loose fasteners. Fasteners should be tightened with care and in accor-
dance with the Torque Specifications table or as specified in the Repair and Service Manual for this vehicle.
BATTERY CHARGING AND MAINTENANCE
Safety
Always observe the following warnings when working on or near batteries.
To prevent battery explosion that could result in severe personal injury or death, keep all smoking
materials, open flames or sparks away from the batteries.
Hydrogen gas is formed when charging batteries. Do not charge batteries without adequate venti-
lation. A 4% concentration of hydrogen gas is explosive.
Be sure the key switch is off and all electrical accessories are turned off before starting work on
the vehicle.
Never disconnect a circuit under load at a battery terminal.
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
BOLT SIZE
Grade 2
1/4" 5/16" 3/8" 7/16" 1/2" 9/16" 5/8" 3/4" 7/8" 1"
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
4
(5)
8
(11)
15
(20)
24
(33)
35
(47)
55
(75)
75
(102)
130
(176)
125
(169)
190
(258)
Grade 5
Grade 8
6
(8)
13
(18)
23
(31)
35
(47)
55
(75)
80
(108)
110
(149)
200
(271)
320
(434)
480
(651)
6
(8)
18
(24)
35
(47)
55
(75)
80
(108)
110
(149)
170
(230)
280
(380)
460
(624)
680
(922)
BOLT SIZE
Class 5.8
(Grade 2)
M4 M5 M6 M8 M10 M12 M14
1
(2)
2
(3)
4
(6)
10
(14)
20
(27)
35
(47)
55
(76.4)
Class 8.8
(Grade 5) 2
(3)
4
(6)
7
(10)
18
(24)
35
(47)
61
(83)
97
(131)
Class 10.9
(Grade 8) 3
(4)
6
(8)
10
(14)
25
(34)
49
(66)
86
(117)
136
(184)
5.8
8.8
10.9
Torque Specifications and Bolt Grades