Gryphon Athena - Manual (Page 15)

Monitor. WARNING! NO ATTEN-
UATION will blink in the display
for 5 seconds, after which you
will be asked to confirm that you
wish to configure Input 3 as a
dedicated AV connection which
bypasses the Athena volume
control. ARE YOU SURE? will
appear in the first line of the dis-
play. NO and YES will appear in
the second line. NO will blink.
If you do NOT wish to make a
dedicated AV connection, press
Monitor while NO is blinking,
then press Menu to select the
next menu-controlled function. If
you do wish to make this con-
nection, press Input Up so that
YES blinks in the display. Press
Monitor. Input 3 is now config-
ured as a dedicated connection
which bypasses the Athena vol-
ume control and should ONLY
be used with a source which has
its own volume control, such as
a surround processor. NEVER
connect a normal line-level
source such as a tuner, CD play-
er, etc. directly to this input, while
it is configured in this manner.
You can always restore Input 3
to normal operation via the
Menu.
When you have configured Input
3, DEDICATE INP.3 TO AV will
appear in the display. Press
Menu to select the next menu-
controlled function.
15
Setting Display
Brightness
You can select and store in
memory the desired level of
brightness in the front-panel dis-
play. When BRIGHTNESS CON-
TROL appears in the display,
press Monitor. BRIGHTNESS
will appear in the first line of the
display. 100% 75% 50% 25%
OFF will appear in the second
line. The 100% indicator will
blink. Press an Input button
repeatedly until the desired level
of brightness blinks. The display
will immediately change to the
selected brightness, unless you
have selected OFF. If OFF is
selected, the display will turn off
after you exit the Menu. Press
Monitor. The selected brightness
level is now stored in memory.
BRIGHTNESS CONTROL will
appear in the display. Press
Menu to select the next menu-
controlled function.
NOTE: When the display is
turned completely off, pressing
any button on the front panel or
on the remote will cause the dis-
play to turn on briefly so that you
can see the current volume level
and selected input. Press a sec-
ond time to activate the desired
function.