Harmonic Resolution Systems R1 Isolation Base - Manual (Page 5)

Specifications
The following specifications are based on your R1 Isolation Base part number.
The part number is composed of the following information sequence.
Series - Model Number - Load Range
R1 Isolation Base Physical Characteristics
Model Number Dimensions
inch (cm) Weight
lbs. (Kg)
1921 19 x 21 x 3
( 48.3 x 53.3 x 7.6 )
22 (10.0)
1719 17 x 19 x 3
( 43.2 x 48.3 x 7.6 )
18 (8.2)
R1 Isolation Base Load Range
Load Range Supported Equipment Load Range
lbs. (Kg)
RD - (Red mark on bottom of
isolator) 0 –60 (0 – 27.3)
GN - (Green mark on bottom of
isolator) 60 – 100 (27.3 – 45.5)
BL - (Blue mark on bottom of
isolator) 100 – 160 (45.5 – 72.7)
Note: The recommended load rage is the range of component weight that will yield optimal
performance. If you have less than recommended load you will still likely obtain very good results based
on HRS technology. Placing more than 10% over the maximum recommended may result in significant
decrease in isolation base performance because there is a safety stop mechanism that will engage that
prevents damage to the isolation base. When the safety mechanism is engaged the performance is
decreased significantly until the isolation base is returned to within rate load range.