Hatteland Display HT B18 (Fanless) - Manual (Page 17)

17
IND100210-6
General Installation Recommendations
Installation
Internal PCI Cards / Brackets dismounting and mounting HT B18
Note: Areas of interest are marked in this section with symbols in RED color. Please power off and disconnect ALL
cables from the computer unit before proceeding!
▼ 1: Unscrew the bottom cover plate (10 pcs of
M3x6mm Torx countersunk screws and lift the cover
up.
▼ 2: Unscrew 6 pcs countersunk screws and remove
both the EMC Bracket (top 2 screws) and PCI Bracket
holder (2 screws inside + 2 x M3x6mm Torx screws in
rear) as indicated.
▼ 3: Now remove the PCI dummy bracket(s) as needed
for the PCI card(s) you want to install. Only remove the
respective dummy bracket for the PCI card(s) you install,
otherwise dust and cooling issues might occur.
▼ 4: Position the PCI card(s) until it stops into the
rear of the computer as arrow#1 indicates. Then, slide
the connector area of the PCI card(s) into the PCI Slot
header(s) gently until it’s fully inserted as arrow #2
shows. Use a firm grip and do not bend/force the cards.
#1
#2
- Repeat the procedure backwards to finalize operation -