Hatteland Display HT B18 (Fanless) - Manual (Page 25)

Physical Overview - HT B18
25
IND100133-40
USB1,2,3,4 INPUT/OUTPUT:
Supports any USB1.1 (12Mbps) or USB2.0 (480Mbps) compliant peripherals. Drivers for most USB devices are
usually included in operating system or on separate installation CD’s delivered with Third Party products. USB 1.1
devices will operate in USB 1.1 mode (12 Mbps).
PS/2 Mouse and PS/2 Keyboard INPUTS:
Connect the PS/2 mouse cable to the PS/2 5P Connector (female) marked with MS.
Connect the PS/2 keyboard cable to the PS/2 5P Connector (female) marked with KB.
HDD LED:
The Power LED Indication will illuminate green when HDD is reading/writing. When there is no HDD activity the LED
will be off.
AC Power INPUT:
The internal AC power module supports both 115VAC/60Hz and 230/50Hz power input using a standard IEC power
housing and is part of the Multipower functionality for the unit.
+ -
DC POWER INPUT:
Connect your DC power cable to the 2P Amphenol FCC17 D-SUB Connector (male). Secure the cable to the hex
spacers provided on the unit, and secure the other end to your power supply. The internal DC power module supports
24VDC and is part of the Multipower functionality for the unit.
GROUNDING SCREW:
Please review “General Installation Chapter”, pt. 6 for more information.
Multi-power note: (For units supporting AC & DC input simultaneously)
The unit has a dual input power supply which will accept both AC and DC input. If both inputs are connected, the
unit will be powered by AC. If AC is disconnected it will automatically switch over to DC without affecting the operation
of the unit. This makes it possible to use AC power as primary power and a 24V battery as secondary power,
eliminating the need for expensive UPS systems.
PCI Slot #1 & #2:
Supports 2 x PCI (Full Height & Length Profile) in two available slots. PCI cards is normally installed from factory or
returned to factory for upgrading if needed.