Lab.gruppen Bridge - Manual (Page 28)

28 DeviceControl Operation Manual
6.6.2 Group view buttons and functions
Press to display current fault and warning icons for the Group or Channel
Press to hide current fault and warning icons for the Group or Channel
Press to display any current faults or warnings on all channels
Press to clear Solo on any Group or Channel (All module only)
Press to show all currently active fault and warning icons by expanding all modules to show a fault/warning detail
row
Press to hide all current faults and warnings
Press to Mute an individual channel or all channels in the Group. Toggles with
Press to Solo an individual channel or only channels assigned to the Group soloed. Toggles with
Press to hide (disable) Solo or Mute button functions. Toggles with
Press to enable Solo or Mute button functions. Toggles with
Press to display Details view for Subnet, Group or Channel
Selects which group of channels is shown
6.6.3 Group view fault and warning indicators
No fault or warning conditions for the Channel or Group
Warning condition for the Channel or Group
Fault condition for the Channel or Group
6.6.4 Channel faults and warnings
Faults
Off fault Device is off but should be on
Service Fuse blown in device. Service required
Temp fault Muted from over-temperature
VHF fault Muted due to excessive Very High Frequency output
Short circuit Muted due to short circuit
Wrong DIP-
switch setting Verification fault on DIP-switches (critical)
6 reference section