Lab.gruppen Bridge - Manual (Page 30)

30 DeviceControl Operation Manual
6.6.6 level meters and clip lEDs
Channel module level meters and clip LEDs indicate level for that channel. Level meters and clip LEDs on the
Group and Subnet modules indicate highest meter value of any channel in the Group or Subnet.
6.7 Power Groups view
6.7.1 Overview
The Power Groups View displays Power Groups in the upper pane and all included devices in each selected
group in the lower pane. Size of the upper pane may be adjusted by clicking and dragging on the bar between
the upper and lower pane.
A number of Power Groups are created by default. These include a group containing all of the Subnets in the
configuration (System) and groups that correspond to each individual Subnet.. Additional Power Groups may
be created by the user. Power Groups may be renamed, and the same device may be assigned to more than
one Power Group. To access the Power Group View, press the Power button on the Toolbar.
6.7.2 The Groups pane
The upper pane (Figure 6.11) shows the default groups and all groups created for the configuration. The On
and Off buttons control power for all devices in the group. If power sequencing is selected in the NBL 60E for
the subnet, then power on will be sequenced as programmed.
Figure 6.11
6.7.3 The Configuration pane
Each selected Power Group’s devices are shown in the lower pane (Figure 6.12). New groups are formed using
the Add Group button in the toolbar. Devices are assigned to groups by clicking in the checkboxes. Individual
amplifiers may be turned on and off using the On button.
Figure 6.12
6 reference section