LG Motorsports LG Diff and Trans Cooler - Manual (Page 2)

Complete Kit (includes all items above plus)
1. (2) Setrab M113 coolers
2. (4) Setrab to -8 cooler fittings
3. (2) Cooler brackets
4. Diff out to pump line approx 12” long (90-45 fittings)
5. Diff pump out to cooler line 53” long (90-45 fittings)
6. Diff cooler out to Diff 62” long (90-45 fittings)
7. Trans out to pump 20” long (90-straight fittings)
8. Trans pump out to cooler 54” long (90-45 fittings)
9. Trans cooler out to Trans 56” long (90-45 fittings)
Optional:
1. Trans fill fitting with temp sensor bung
Instructions:
Prep:
Some of the install of this kit my require special tools. Most DYI owners should
have the needed tools for install. If you have any questions, or do not feel comfortable
about install, please contact LG for a local shop near you. You will need to raise the car
and support with jack stands or lift enough to be able to access your diff and
transmission.
Install:
Once your car is supported you will need to drain the transmission and differential
of their fluids and remove both the drain and fill plugs on both units. Once the fluid has
been drained, please remove the rear diff cover and set to the side. The cover, drain/fill
plugs, nor the stock bolts will be re-used.
Start by inserting the fittings into the trans and diff in their respective locations
where the fill and drains are located. The ½” to -8 fittings will be installed into the trans,
and the M18 fittings will go into the diff. You will need Teflon tape or similar for the
trans fittings, the diff fittings install dry, just make sure the crush washer/o-ring is on the
fitting when they go in. You can also hand tighten the filters onto these fittings as the
filters will help keep debris from entering the pump. These can be taken apart for
inspection from time to time as well.