LG Motorsports LG C6 Z06 Adjustable Exhaust Switch - Manual (Page 3)

The next step in the operation is to remove some of the side trim panels and pull the
carpet back to run the wires to the fuse block located behind the kick panel in the
passenger side foot well. This is done by first pulling up on the parking brake handle and
unclipping the front part of the boot to get to two screws that hold the side trim panel in
place. The side trim panel needs to have 2 bolts removed by using a 7mm nut driver then
gently unclipping the panel at the front and removing the panel to pull the carpet back to
run the wires.
Figure 2: Removal of parking brake boot and side trim panel.
Installation:
Now we are ready to install your new LG Motorsports exhaust switch. First we are going
to start by running the wire through the open hole in the center console. Run the wire,
fuse, and ground through under the center console trim and out on the underside of the
parking brake boot. Now run the wire under the shifter/parking brake trim panel over to
the carpet area where we had opened up by removing the side panel as shown in the
lower right picture in figure 2. At this point you can now install your new trim piece with
the installed switch in the console and click into place as shown in figure 3. The next
thing that we need to install if you have the lighted switch is the ground. GM was kind
enough to give us a ground location already on the side of the tunnel with a bolt already
installed. You will need the 10mm socket and ratchet to remove this bolt and place our
ground strap in place at this location as shown in figure 4.