LG Motorsports LG C6 Z06 Adjustable Exhaust Switch User Manual
Page 5
Figure 5: Fuse panel door open and removal of factory fuse
After locating the top of the plug in you will need to place this into the fuse box where
we have removed the factory 10amp fuse that controlled the plates from the factory.
Figure 6: Fuse tap with marking
The location of the factory fuse is located at the very bottom right hand side of the fuse
box and is shown in figure 5. Remove the factory 10amp fuse at this time with the
supplied removing tool in your fuse box. Now you can install your wiring harness into
the open slot in the fuse panel, again remember to install with the white dot facing up for
lighted switches. Now you have completed your wiring harness installation with the new
switch. At this point you just need to fold the fuse box door shut and pull the carpet back
up, snap in your side trim panel and install the 2 screws that you removed to secure this
panel back on, and clip the front part of the parking brake boot back into place.
Figure 7: round lighted switch installed