Luxul XAP-1230 - Manual (Page 5)

Simply Connected
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
5
Back Panel
The back of the XAP-1230 provides two SMA antenna connectors and one RJ-45
connection that is used to deliver both power and data to the access point.
RESET
XAP-1230 Rear Panel
Reset Button:
The Reset button is used to clear the current settings of the XAP-1230 and restore
factory default settings.
To Restore the Default Settings: With the XAP-1230 powered on, press and hold
the Reset button for 15 seconds. When all the LEDs except the power LED turn off,
release the reset button. The power LED will stay solid. The XAP-1230 will be set to
factory defaults.
CAUTION: Pressing and holding the Reset button will remove any
custom configurations done to the XAP-1230.
Bottom Panel
The Bottom of the XAP-1230 has two key holes to allow for easy and flexible
mounting on a wall or other solid surface. For desktop or shelf mounting, it also
has guides for placement of the four rubber feet provided.
PREPARING FOR INSTALLATION
System and Power Requirements
„
Computer supporting TCP/IP and equipped with a Web browser. Supported
Web browser versions include, Microsoft IE 8.0 and up, Mozilla Firefox 10 and up,
Safari 2.0 and up, Google Chrome 4.0 and up, Opera 10 and up. The Web browser
is used to configure the XAP-1230.
„
The PoE injector power supply requires AC100V ~ 240V, 50Hz ~ 60Hz.