Luxul XAP-1230 - Manual (Page 7)

Simply Connected
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
7
Install Included Rubber Feet in the Impressions in the bottom of the XAP-1230
Connecting the Ethernet Cable
With the XAP-1230 properly mounted and the Antennas installed, you can now
plug the Ethernet Cable into the RJ-45 connector.
NOTE: Category-5, super Category-5 or Category-6 unshielded twisted
pair (CAT5/CAT5e/CAT6 UTP) cables can be used. For best
results, it is recommended that Category-6 shielded twisted pair
be used to ensure stable data transmission at highest data rates.
Connecting to the Power Source
The XAP-1230 is PoE ready and supports 802.3at PoE. A PoE injector is included
with the device. To apply power, simply connect the opposite end of the Ethernet
cable to which the access point is already connected to the provided PoE injector
or other PoE switch or injector. An Ethernet cable length of up to 300 feet can be
used. DO NOT yet apply power to the PoE injector or switch.
PoE Injector Setup
„
Data In: Connect an Ethernet cable from your router or switch
to the
Data In port of the included PoE Injector
„
Data & Power Out: Connect an Ethernet cable from the Data & Power Out
port of the included PoE Injector to the
PoE Port of the XAP-1230
„
AC Power: Connect the included AC Cord to the Power Input of the Included
Injector first and then to the AC outlet.
NOTE: The XAP-1230 is not a router and will need to be connected to
a network with a router in order to deliver Internet access.