Dynex DX-LCD37-09 - Manual (Page 16)

16 Using your TV
For a 16:9 video signal
• Normal–Squeezes the picture horizontally to be displayed at
4:3. Black bars appear on the sides of the picture.
• Zoom–Enlarges the center of the picture. The outer part of the
picture is cropped.
• Wide—Displays the picture at its original size.
• Cinema—Displays the picture at its maximum size without
changing its aspect ratio. The outer part of the picture is cropped.
For a computer image
• Normal—Stretches the image proportionally. Black bars
appears on the sides of the image. Availability of this option
depends on the aspect ratio of the input signal.
• Wide—Stretches the image to fill the screen.
• Dot-by-Dot—Displays the image in its original size.
Setting the sleep timer
To set the sleep timer:
• Press SLEEP repeatedly to select the amount of time you want
your TV to wait before it turns itself off. You can select 30min,
60min, 90min, or 120min.
• To turn off the timer before it expires, press SLEEP repeatedly
until Sleep Off appears.
Note: If you unplug the power cord or a power failure occurs, the sleep
timer is canceled.
Checking the antenna signal strength
To check the antenna signal strength:
1 Press MENU. The on-screen menu opens.
2 Press or to select CHANNEL, then press ENTER.
3 Press or to select Antenna, then press ENTER.
4 Press the number buttons or CH or CH to select the channel
you want to check the signal strength for. A screen opens that
shows the signal strength.
If the video input source is not TV, the following screen opens.
You cannot check the signal strength when the video input
source is an external device.
5 Press MENU to close the menu.
Normal Zoom
Cinema Wide
Normal Wide
Dot-by-Dot
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
Antenna Antenna
Back
Ch Change CH
Now 0 0 Peak
Antenna Antenna
Back
Ch Change CH
Indicator is available
for antenna signal only.